For reducing the cost of steel making!! Sharp decrease in Electrode consumption with simple coating method!!! High performance antioxidant for Graphite Electrode!!!!

	Size of the tub and quantity of EL-300
	The dimensions of the steel tub should be approximately 20” longer than the overall length of the electrode and pre-set nipple and level of EL-300 should be approximately 4” higher than the top of surface of the electrode. Using a tub larger than suggested will result in the waste of and a higher cost of EL-300. The following table shows the required amount of EL-300 to be kept as well as the dimensions of the tubs to be used for various size electrodes.
	Diameter Length of Electrode(mm) Pole + Nipple = Total Dimension of Tub(mm) Width x Depth x Length Required EL-300 (kgs) inch mm 8 200 1500 + 89 = 1589 300 x 450 x 1900 140 14 350 1800 + 153 =1953 500 x 650 x 2200 420 16 400 1800 + 170 = 1970 550 x 700 x 2250 500 18 460 1800 + 170 = 1970 600 x 800 x 2300 600 20 510 1800 + 178 = 1978 700 x 900 x 2400 900 20 510 2100 + 178 = 2278 700 x 900 x 2650 980 24 610 2400 + 186 = 2586 800 x 1000 x 3000 1370 28 710 2800 + 280 = 3080 900 x 1100 x 3500 1940 Table 1) Dimension of Tub and Required EL-300 (per one charge)